Table of Contents
Advertisement
8.1.4
TENSIONING __________________________________________________________
Counterweight
Tensioning
V-belt pulleys
MAINTENANCE AND LUBRICATION 8
Nuts
Bolt
Release
Lock nut
Straight Edge
•
Loosen the nuts but do not remove them.
•
Loosen the lock nut.
•
Use the bolt to set the V-belt tension, This can be
checked via the inspection opening. When pressed
under a load of 6kg the V-belt must not be able to
move more than 10mm.
•
Via the counter-weight.
•
Tighten the lock nut again.
•
Check the alignment of the V-belt pulleys. Use
Straight Edge (Ruler) or similar. The straight edge
must lie flat on both V-belt pulleys and must
be properly aligned.
en-73
Advertisement
Table of Contents
