Henny Penny CFE-415 Operator's Manual page 79

5-5
DIAGNOSTIC MODE
DETAILS
(CONT.)
March 2015
If any of the product settings do not match original values, the following
message is displayed (with one or more of the product numbers blink-
ing):
"10: PROD'S 123456"
"10: DO NOT MATCH"
"10: ORIG. VALUES"
In this case, the blinking numbers indicate which products do not match
original settings. If the numbers 3 and 5 are the only numbers blinking,
then product #3 and product #5 each have at least one setting changed
from their factory preset values. Products 1, 2, 4, and 6 are confirmed to
exactly match their original settings.
The second item in section 10 identifies how many items in CFA Pro-
gramming Mode have been changed from their original values. These
Chick-fil-A settings mainly deal with special Chick-fil-A controller
features like Oil Wear, Heat-up Monitoring, New Oil Compensation, Oil
Idle Compensation, Drop Detection, Clean-out Mode, and Amps and
Voltage alarms.
If all items in CFA Prog. Mode match their original, factory preset val-
ues, the following report is made:
"10: ALL CFA ITEMS"
"10: MATCH"
"10: ORIG. VALUES"
If any of the items in CFA Prog. Mode do not match their original values,
the following message is displayed (with the actual number of changed
items):
"10: 2 CFA ITEMS"
"10: DO NOT MATCH"
"10: ORIG. VALUES'
A similar report is made for Special Program Mode. Special Program
(SP) Mode settings deal with °F/°C display, speaker tone and volume,
Melt and Idle Modes, and how the product buttons function (start cook or
merely select product).
"10: ALL SP ITEMS" "10: 1 SP ITEMS"
"10: MATCH"
"10: ORIG. VALUES" "10: ORIG. VALUES"
75
Model CFE-415, 427
"10: DO NOT MATCH"