Henny Penny CFE-415 Operator's Manual page 70

5-5
DIAGNOSTIC MODE
DETAILS
(CONT.)
March 2015
If the fryer has witnessed two or more low voltage warnings today, the
following report is displayed:
"D4: CAN'T TEST"
"D4: HEAT CAPACITY"
"D4: DUE TO"
"D4: VOLTAGE"
"D4: PROBLEMS"
Otherwise, if the assessed heat capacity rating is presently "good" and at
most only one heat-up today that failed to achieve the expected rate, the
following report is displayed:
"D4: HEATING"
"D4: CAPACITY"
"D4: IS FINE"
Otherwise, if the heat capacity is presently assessed as "bad", or present-
ly assessed as "good" but two or more heat-ups today have not reached
the expected heat-up rate, the following report sequence is generated:
"D4: YOU HAD 75%"
"D4: SLOW HEATS"
"D4: TODAY"
(Press ▼)
"D4: HAVE 20%"
"D4: SLOW HEATS"
"D4: THIS OIL"
(Press ▼)
"D4: HAD 0%"
"D4: SLOW HEATS"
"D4: LAST OIL"
(Press ▼)
If the heat capacity is assessed as bad (low heat-up rate on last heat-up,
and on three of the last four heat-ups), then the heating coils are suspect
and the following is displayed:
"D4: CHECK COILS,"
"D4: CONTACTORS,"
"D4: AND WIRING"
66
Model CFE-415, 427