Henny Penny CFE-415 Operator's Manual page 53

4-1
INFORMATION MODE
DETAILS
(CONT.)
March 2015
16. CPU TEMPERATURE
This step shows the present PC board temperature.
Press to continue onto the ANALOG reading.
17. ANALOG <1> 2344
This step displays the present status of any channel of the controller's a
to d converter. This feature may be useful to a technician troubleshoot-
ing the fryer or controller.
The displayed value can be toggled between volts and bits by press-
ing . If the displayed value has a decimal point, it is voltage (0 to 5
VDC). If no decimal point is shown, the value is a-to-d bits (0 - 4095).
Press to continue onto AC VOLTS reading.
18. AC VOLTS 98%
This item displays the present status of the line voltage supply to the
fryer. The displayed value is averaged over a 10-second period, so brief
dips or fluctuations in the voltage might not show up in this display.
The voltage is normally displayed as a "percent of nominal" value, where
100% would indicate that voltage is right on the nominal value (i.e. 208
volts for a 208v fryer). The display
can be toggled to an actual voltage value by pressing
Press to continue onto AMPS reading.
19. AMPS
For electric fryers, this display shows the present readings from the
fryer's amps sensors, which monitor the electrical current supplied to the
heaters.
On open fryers, these values indicate the current through each individual
heater coil. On 208 or 240 volt units, this value should be close to the
value on the data plate. On 480 volt fryers, this value should be the
value on the data plate multiplied by 1.76.
The "amps" values should normally cycle on and off with the HEAT ON
light, and all three values should be about the same.
Press and hold to exit Information Mode at any time, or after 2 min-
utes, controls automatically exit back to normal operation.
49
Model CFE-415, 427
.