Omron H3CR-A Manual page 67

H3DR-A/P/M
Accessories (Order Separately)
Mounting Track 50 cm (l) x 7.3 mm (t)
1 m (l) x 7.3 mm (t)
1 m (l) x 16 mm (t)
End Plate PFP-M
Spacer PFP-S
Specifications
General
Item
Operating mode A: ON-delay
B: Flicker OFF start
B2: Flicker ON start
C: Signal ON/OFF-delay
D: Signal OFF-delay
E: Interval
Terminal block 11/12 terminal
Input type No-voltage input
(NPN Model)
Output type H3DR-A: Relay output (DPDT);
H3DR-AS: Transistor output
Mounting method DIN track mounting
EMC Emission Enclosure:
Emission AC Mains:
Immunity ESD:
Immunity RF-interference:
Immunity Conducted Disturbance: ENV50141: 10 V (0.15 to 80 MHz) (level 3)
Immunity Burst:
Approved standards UL508, CSA C22.2 No.14
Conforms to VDE 0435/2021 C/250, C/30 (-AS model), VDE 0110, VDE0106/P100,
IEC947 AC-15 (-Pj and -M models), AC-13 (-Aj model), DC-13 (-ASj model)
Conforms to EN50081-2, prEN50082-2
Note: The internal circuits are optically isolated from the output. This enables application of either NPN or PNP transistors.
Time Ranges
H3DR-Aj/-ASj/-Pj
Time unit
Setting 0
Time scale: x 0.1
Time scale: x 1
Note: To obtain instantaneous output, set the value below zero.
H3DR-M Single-time Range
Rated time
1 s 0.1 to 1 s
5 s 0.2 to 5 s
10 s 0.5 to 10 s
30 s 1 to 30 s
60 s 2 to 60 s
10 min 0.5 to 10 min
PFP-50N
PFP-100N
PFP-100N2
H3DR-A/-AS H3DR-AP/-ASP
Voltage input
(PNP Model)
(NPN/PNP) (see note)
s (sec)
Instantaneous output (see note)
0.1 to 1.2
1 to 12
Time range
H3DR-P
6/12 terminal
No-voltage input
(NPN Model)
Relay output (SPDT)
EN55011 Group 1 class A
EN55011 Group 1 class A
IEC801-2: 4 kV contact discharge (level 2)
8 kV air discharge (level 3)
ENV50140: 10 V/m (80 MHz to 1 GHz) (level 3)
IEC801-4: 2 kV power-line (level 3)
2 kV I/O signal-line (level 4)
min h (hrs)
H3DR-A/P/M
H3DR-PP H3DR-M
ON-delay
5/12 terminal
Voltage input ---
(PNP Model)
x10 h (10 h)
1 to 12
10 to 120
67