H2E - Omron H3CR-A Manual

24-hour Time Switch
ON/OFF Operation in Units of
15 Minutes
The only requirement for time setting is the
plugging of a setting pin into the desired hole on the
dial.
Permits manual ON/OFF operation independent of
the set time.
A power indicator lamp is provided, which permits
monitoring even during the night.
Ordering Information
Classification Control output
Standard type SPST-NO
Dual-circuit type DPST-NO
Note: 1. Specify both the model number and supply voltage when ordering. All H2E-series Timers are supplied with two pairs of setting pins
(one pair for each ON operation and OFF operation) as the standard accessories. If more setting pins are required, also specify the
required number of setting pins.
2. For the flush mounting types, a mounting bracket is supplied.
3. Repetitive operations can be performed in a cycle of 24 hrs.
Specifications
Time Ranges
Item
Type
Operation period
Minimum division
Minimum set time
Maximum set time
Ratings
Rated supply voltage
Operating voltage range
Power consumption
Control outputs
270
One cycle time
24 hrs 15 min
30 min
H2E, H2E-Y
Daily
24-hour
15 min
15 min
23 hrs 45 min
100/110 or 200/220 VAC (50/60 Hz)
85% to 110% of rated supply voltage
Approx. 2 VA
15 A at 250 VAC, resistive load (cos% = 1) (max. operating voltage: 250 VAC)
Min. setting time Mounting method
Surface mounting
Flush mounting
Surface mounting
Flush mounting
30 min
24 hrs

H2E

Model
H2E
H2E-Y
H2E-2
H2E-Y2
H2E-2, H2E-Y2