Omron H3CR-A Manual page 165

H5BR
Setting Item Table
Mode Setting item
Run mode Set value
Batch count set
value
Setting mode Time range*
UP/DOWN mode
Output mode
Output time
Input signal time
Key protect level
Note: 1. Changes made in setting mode become effective when run mode is entered.
2. The time range setting appears first when setting mode is entered.
Discription
Compared to the present value.
Determines the timing of the
control output according to the
output mode.
Turns ON the batch output when
the preset number of cycles have
been completed.
Determines the timing range.
Selects
Determines the form of the control
output. (Refer to the present value
vs. output diagrams on page 10 to
12.)
Determines the duration of the
control output.
Will be displayed when the output
mode is A, A-1, A-2, A-3, b, or
b-1. Will not be displayed when
the output mode is d, E, or F.
Changes the duration of the
control and reset input signals.
Locks certain keys to prevent
accidental operation. The key
protection level, kP-1 to kP-4,
determines which keys are locked
when the key protection input is
ON. The locked keys are crossed
out in the diagram on the right.
Setting procedure
Sequence when changing a digit using the incre-
ment
keys (1 to 4).
0 1 2
Sequence when changing a digit using the incre-
ment
keys (1 to 4).
0 1 2
Change the timing range with the increment keys (1 to 4).
Select UP/DOWN with the increment keys (1 to 4).
u
(UP)
Sequence when changing the mode using the increment
keys (1 to 4).
a a- -1 a- -2 a- -3
Use keys 1 to 3 to change the value.
Key1 adjusts the first digit (0.1's digit).
Key2 adjusts the second digit (1's digit).
Key3 adjusts the third digit (10's digit).
0 1 2
Key4 selects either hold output or one-shot output.
hold
Change the duration with the increment keys (1 to 4).
(1 ms)
1
Sequence when changing the key protect level using the
increment keys (1 to 4).
1 2
p p
<KP--1>
<KP--3>
H5BR
8 9
8 9
d
(DOWN)
b b- -1 d e f
8 9
0 0
. s
(20 ms)
20
3 4
p p
<KP--2>
<KP--3>
165