Omron H3CR-A Manual page 244

H5S
Operation
Operation Function
Timer operation
Pulse-output operation
Cyclic operation
Forced ON/OFF operation
Operation on power restoration
Day override operation
Programming
Before setting the parameters necessary for each operation, the operation of circuits (outputs) 1 and 2 must be determined. Also, whether the
operation is restarted automatically or manually after power failure recovery should be specified.
244
Controls the output according to the set time of ON and OFF (the time can be set in units of
1 min)
Produces the output for a fixed duration at the set ON (pulse width: 1 to 59 s, or 1 to 59 min).
The pulse width can be set in units of 1 s or 1 min.
The pulse width can be set for each step.
Repeatedly performs an ON/OFF operation during a specific period, which can be set in units
of 1 min.
Forcibly turns ON/OFF the output by a side switch
AUTO: Operation is automatically started on power recovery
MANUAL: Operation is started by applying an external signal after power recovery
Executes a day's operation on another day. (The specified new operation is performed only for
one week.)
In this example, circuit 1 performs an
ordinary timer operation, while circuit 2
performs a pulse output operation.
Operate the switch
pins with the tip of a
ballpoint pen, etc.
The automatic operation restarting
mode is set in this example.
Operate the switch pins with the tip
of a ballpoint pen, etc.
H5S