Page 1
Digital Timer H5CL Easy-to-see and Easy-to-operate DIN 48 x 48 mm Digital Timer with IP66/NEMA 4 Protection Water- and dust-protected for severe environ- ments. Large, high-visibility LED displays with a height of 12 mm. Simple setting with Increment and Decrement Keys.
H5CL H5CL Specifications Item H5CL-A (AC models) H5CL-AD (DC models) Classification Digital timer Mounting DIN track, surface, and flush mounting Flush mounting (common) External connections Socket Screw terminals Enclosure ratings Panel surface: IEC IP66 and NEMA Type 4 (indoors) when Y92S-29 rubber packing is used.
Page 3
Signal start, at transistor output model: 0.005% 3 ms max. (see note 1 and 2) If the set value is within the sensor waiting time (250 ms max.) in the case of power start, the control output of the H5CL will not be turned ON until the sensor waiting time passes. Insulation resistance 100 MΩ...
Note: Switches 1 to 6 are all set to OFF before shipping. (The same switch settings apply to AC and DC models) Timer Control with Power Start When using the H5CL with power start, short-circuit the start input and input 0-V terminals. Downloaded from Elcodis.com...
H5CL H5CL Operating Modes A Mode Power Signal ON-delay Start Gate Reset Control output Set value Display mode Set value DOWN F Mode Accumulative Operation Power Start Gate Reset Control output Set value Display mode Set value DOWN Dimensions Note: All units are in millimeters unless otherwise indicated.
Page 6
3. When the Timers are mounted closely side by side, the Timers will not be water-resistive. DIN Track Mounting H5CL-A P2CF-11 H5CL-AD -500 The cover conforms to finger protection standard against electric shock. (VDE 0106/P100) 47.5 64.5 Downloaded from Elcodis.com...
Page 10
Correction Set value DIP Switch Selection status after correction DIP switch setting while the H5CL is turned on will not be valid until the H5CL is turned off and on. No change Press RST Key or turn power off and then...
Page 11
H5CL H5CL Downloaded from Elcodis.com electronic components distributor...
Page 12
H5CL H5CL ALL DIMENSIONS SHOWN ARE IN MILLIMETERS. To convert millimeters into inches, multiply by 0.03937. To convert grams into ounces, multiply by 0.03527. Cat. No. L085-E1-3 In the interest of product improvement, specifications are subject to change without notice.