Table of Contents
Advertisement
402 Wheels and tyres
The jack is maintenance-free. If there is a
malfunction, please contact a qualified spe‐
cialist workshop.
The tyre-change tool kit is located under the
boot floor.
1
Ratchet
2
Centring pin
3
Jacking support
4
Jack
5
Wheel wrench
6
Folding chock
Setting up the folding chock
Preparing the vehicle for a wheel change
Requirements:
The required tyre-change tool kit is available.
R
If your vehicle is not equipped with the tyre-
change tool kit, consult a qualified specialist
workshop to find out about suitable tools.
The vehicle is not on a slope.
R
The vehicle is on solid, non-slippery and level
R
ground.
Apply the electric parking brake manually.
#
Move the front wheels to the straight-ahead
#
position.
Vehicles with automatic transmission:
#
shift into position j.
Vehicles with AIR BODY CONTROL: set the
#
normal vehicle level (
page 191).
→
Switch off the engine.
#
Make sure that the engine cannot be started.
#
Place chocks or other suitable items under
#
the front and rear of the wheel that is diago‐
nally opposite the wheel you wish to change.
Remove the hub caps if necessary
#
(
page 403).
→
Raising the vehicle (
page 403).
→
#
Advertisement
Table of Contents
