Table of Contents
Advertisement
To switch off/reduce the level: press but‐
#
ton
1
repeatedly until the desired ventila‐
tion level is set.
If all indicator lamps are off, the seat ventila‐
tion is switched off.
%
If you switch the power supply off and on
again within 20 minutes, the previous setting
of the seat ventilation for the driver's seat
remains active.
Switching AIRSCARF on/off
& WARNING Risk of burns caused by the
heating output from AIRSCARF being too
high
When AIRSCARF is switched on, very hot air
can flow from the outlet opening in the head
restraints.
This could result in burns in the immediate
vicinity of the outlet opening.
Turn the heating output down in good
#
time.
Maintain a suitable distance from the
#
outlet opening.
Requirements:
The power supply is switched on.
R
AIRSCARF warms the head and neck area of
vehicle occupants with warm air. The warm air
flows out of the vents in the head restraints.
Seats and stowing 101
To switch on/increase the level: press but‐
#
ton
1
repeatedly until the desired heating
level is set.
Depending on the heating level, up to three
indicator lamps light up.
To switch off/reduce the level: press but‐
#
ton
1
repeatedly until the desired heating
level is set.
If all of the indicator lamps are off, AIRSCARF
is switched off.
%
When switching on, the blower starts up only
after a preheating phase which lasts a few
seconds.
After switching off, the blower runs on for a
few seconds to cool down the heating ele‐
ments.
%
If the vehicle battery voltage is too low, AIR‐
SCARF may switch off.
Adjusting the AIRSCARF vent (
#
Make sure that there are no objects covering the
intake grille on the back of the head restraint.
Make sure that objects do not enter the vents in
the head restraints.
page 137).
→
Advertisement
Table of Contents
