Table of Contents
Advertisement
Display in the assistance graphic
1
Spotlight function switched on but not oper‐
ating
2
Spotlight function switched on and operating
The pedestrian symbol in the assistance graphic
indicates the status of the spotlight function. If
the pedestrian symbol is displayed dark 1, the
function is switched on. If the symbol is dis‐
played bright 2, the conditions for the Spotlight
function are also fulfilled.
System limitations
The spotlight function does not flash at animals.
The spotlight function is not active or is active
only to a limited extent if:
You are driving in urban traffic.
R
The pedestrians are located in the area of an
R
oncoming vehicle or a vehicle in front.
Activating/deactivating the spotlight func‐
tion
Requirements:
Pedestrian detection is active (
R
The carriageway is not lit.
R
The speed is at least 60 km/h.
R
Adaptive Highbeam Assist Plus is switched
R
on.
If all the requirements are fulfilled, the headlamp
flashes four short pulses at a pedestrian detec‐
ted on or near to the carriageway.
Multimedia system:
Vehicle
,
tings
Spotlight
.
Switch the function on O or off ª.
#
Blind Spot Assist and Active Blind Spot
Assist
Function of Blind Spot Assist and Active
Blind Spot Assist
Blind Spot Assist uses two lateral, rear-facing
radar sensors to monitor the area up to 40 m
behind your vehicle and 3 m directly next to your
vehicle.
page 211).
→
If a vehicle is detected at speeds above approx‐
imately 12 km/h and this vehicle subsequently
enters the monitoring range directly next to your
vehicle, the warning lamp in the outside mirror
lights up red.
If a vehicle is detected close to your vehicle in
the lateral monitoring range and you switch on
the turn signal indicator in the corresponding
direction, a warning tone sounds once. The red
warning lamp in the outside mirror flashes. If the
Driving and parking 213
÷
Light set-
.
.
Advertisement
Table of Contents
