Table of Contents
Advertisement
Therefore, place the filling hose in the
#
plastic bag that contained the TIREFIT
kit.
+
ENVIRONMENTAL NOTE Environmental
pollution caused by environmentally irre‐
sponsible disposal
Tyre sealant contains pollutants.
Have the tyre sealant bottle disposed of
#
professionally, e.g. at a Mercedes-Benz
Service Centre.
Switch off the tyre inflation compressor.
#
Unscrew the filling hose from the valve of the
#
defective tyre.
Store the tyre sealant bottle, the tyre infla‐
#
tion compressor and the warning triangle.
Pull away immediately.
#
Stop driving after approximately ten minutes
#
and check the tyre pressure using the tyre
inflation compressor.
The tyre pressure must now be at least
130 kPa (1.3 bar/19 psi).
& WARNING Risk of accident due to the
specified tyre pressure not being ach‐
ieved
If the specified tyre pressure is not achieved
after a brief drive, the tyre is too badly dam‐
aged. The tyre sealant cannot repair the tyre
in this instance.
Damaged tyres and a tyre pressure that is
too low can significantly impair braking and
handling characteristics.
Do not drive on.
#
Consult a qualified specialist workshop.
#
Countries that have Mercedes-Benz
Service24h: a sticker with the telephone num‐
ber can also be found in your vehicle, e.g. on the
B‑pillar on the driver's side.
Correct the tyre pressure if it is still at least
#
130 kPa (1.3 bar/19 psi). See the tyre pres‐
sure table on the fuel filler flap for values.
To increase the tyre pressure: switch on
#
the tyre inflation compressor.
Breakdown assistance 375
To reduce the tyre pressure: press pres‐
#
sure release button
1
next to manometer
2.
When the tyre pressure is correct, unscrew
#
the filling hose from the valve of the sealed
tyre.
Screw the valve cap onto the valve of the
#
sealed tyre.
Pull the tyre sealant bottle out of the tyre
#
inflation compressor.
The filling hose stays on the tyre sealant bot‐
tle.
Advertisement
Table of Contents
