Global Vlan1Q Tagged Vlan Configuration Commands; Figure 32-1 Tagged Vlan Configuration And Activation Example; Figure 32-2 Cpu Vlan Configuration And Activation Example - ZyXEL Communications GS-3012 User Manual

GS-3012/GS-3012F User's Guide
The following procedure shows you how to configure tagged VLAN.
Use the IEEE 802.1Q tagged VLAN commands to configure tagged VLAN for the switch.
1.
Use the
2.
vlan <vlan-id>
automatically enters the
Use the command when you are finished configuring the VLAN.
3.
exit
Use the
4.
interface <port-list> command
on a port, then use the pvid <vlan-id> command to set the VLAN ID you created for the port-list to
that specific port in the PVID table.
Use the
5.
inactive
Example:
ras(config)# vlan 2000
ras(config-vlan)# name upl
ras(config-vlan)# fixed 10-12
ras(config-vlan)# no untagged 10-12
ras(config-vlan)# exit
ras(config)# interface port-channel 10-12
ras(config-interface)# pvid 2000
ras(config-interface)# exit
ras(config)#

Figure 32-1 Tagged VLAN Configuration and Activation Example

Configure your management VLAN.
6.
Use the
vlan <vlan-id>
and the switch will activate the new management VLAN.
Use the
inactive
Example:
ras(config)# vlan 3
ras(config-vlan)# inactive
ras(config-vlan)#

Figure 32-2 CPU VLAN Configuration and Activation Example

32.4 Global VLAN1Q Tagged VLAN Configuration Commands

This section shows you how to configure and monitor the IEEE 802.1Q Tagged VLAN.
32.4.1 GARP Status
Syntax:
show garp
This command shows the switch's GARP timer settings, including the join, leave and leave all timers.
32-2
command to configure or create a VLAN on the switch. The switch
mode.
config-vlan
command to deactivate the VLAN(s).
command to create a VLAN (VID 3 in this example) for managing the switch,
command to disable the new management VLAN.
to enter the config-interface mode to set the VLAN settings
IEEE 802.1Q Tagged VLAN Commands