Table of Contents
Advertisement
4.2
Basic Installation
Please follow the steps below to mount the camera to the wall.
For the Cable Management Model:
1.
Before screwing the camera to the wall, drill four holes on the wall according to the hole-positions
on the supplied Quick-Mounting Ring. If you wish to run the wires into the wall, drill another hole
in the middle of the circular area within the Quick-Mounting Ring.
2.
Push the supplied four anchors into the four holes on the wall. Place the Quick-Mounting Ring
against the anchoring surface so that the holes line up. Screw the Quick-Mounting Ring to the wall
using the supplied Long Screws.
Long Screws
Quick-Mounting Ring
3.
Screw the Camera Base to the Quick-Mounting Ring using the supplied four Short Screws.
You can wire the cables from the side of the camera or through the wall.
Wire the cables from
the side of the camera
Anchors
Wall
Short Screws
Short Screws
Wire the cables
through the wall
6
EZN1160/1260/1360
Camera Base
Quick-Mounting Ring
Advertisement
Table of Contents
