Basic Installation; Mounting And Wiring - EverFocus EBN288/368 User Manual

Reset Button
1. Reboot the camera:
When the camera is powered up, press the Reset Button will reboot the camera.
2. Restore the camera:
Keep the Reset Button pressed, at the same time unplug the camera power then plug it back again
will return camera settings to the factory default values.

4.4. Basic Installation

4.4.1.

Mounting and Wiring

EBN288/368
1. Before screwing the camera to the wall, stick the Sticker on the wall / ceiling to mark the position
for installation. Drill four holes on the wall / ceiling according to the supplied Sticker and push the
supplied four Screw Anchors into the four holes on the wall / ceiling. Drill another hole in the
middle of the Sticker if you wish to run the wires into the wall / ceiling.
2. Twist the Outer Housing counterclockwise and then remove the Outer Housing from the camera
base.
3. Place the camera base on the wall / ceiling and run the cable through the camera base first.
Value IP 2MP 288 Series / 3MP 368 Series
10