Platform Components; Platform; How To Remove The Platform - Gs-1432M, Gs-1932M, Gs-1932M Lite, Gs-1932M Xh - Terex Genie GS-1330m Service And Repair Manual

August 2021
10-1

Platform

How to Remove the Platform - How to Re mov e th e Platfo rm - GS- 143 2m, GS-19 32 m, GS- 193 2m Li te, GS -19 32m XH
GS-1432m, GS-1932m, GS-1932m
Lite, GS-1932m XH
Perform this procedure with the platform extension
fully retracted and locked in position.
Note: Perform this procedure with all external AC
power disconnected from the machine.
1 Raise the platform to approximately 3 ft / 1 m.
2 Disconnect the battery pack from the
machine.
Electrocution/burn hazard.
Contact with electrically charged
circuits could result in death or
serious injury. Remove all rings,
watches and other jewelry.
3 Disconnect the platform controls from the
control cable at the platform.
4 Remove the cover from the AC outlet. Tag
and disconnect the wiring from the outlet.
Electrocution/burn hazard.
Contact with electrically charged
circuits could result in death or
serious injury. Remove all rings,
watches and other jewelry.
5 Disconnect the wiring from the platform and
pull the wiring free of the platform.
Models with air line to platform option:
Disconnect the air line from the platform. Pull
the air line free of the platform.
Part No. 1309020GT
6
7
8
9
10 Carefully rotate the platform approximately
11 Carefully lift the platform off of the machine
Note: Take notice of the wear pad position before
the platform is removed. Correct wear pad position
is essential for proper platform functionality.
GS ™ -30m • 32m • 30 • 32 • 46 • 55
Service and Repair Manual

Platform Components

Attach straps from an overhead supporting
device to the lanyard anchorage points on the
platform railings at the non-steer end of the
machine. Apply slight lifting pressure.
Remove the pivot pins securing the platform
to the scissor assembly.
Attach straps from an overhead supporting
device to the lanyard anchorage points on the
platform railings at the steer end of the
machine.
Crushing hazard. The platform
will fall if not properly supported.
Apply just enough lifting pressure to separate
the slide wear pads from the platform.
30° in either direction.
and place it on a structure capable of
supporting it.
167