Terex Genie GS-1330m Service And Repair Manual page 161

August 2021
13 Remove the fasteners from the lift cylinder
rod-end pivot pin. Use a soft metal drift to
remove the pin.
Crushing hazard. The lift
cylinder will fall if not properly
supported when the pivot pin is
removed.
14 Lower the cylinder onto the lower scissor arm.
15 Attach a lifting strap from an overhead
supporting device to the barrel-end of the lift
cylinder.
16 Remove the fasteners from the lift cylinder
barrel-end pivot pin. Use a soft metal drift to
remove the pin.
Crushing hazard. The lift
cylinder will fall if not properly
supported when the pivot pin is
removed.
17 Support and secure the lift cylinder to an
appropriate lifting device.
18 Remove the lift cylinder through the scissor
arms at the steer end of the machine.
Crushing hazard. The lift
cylinder will become unbalanced
and fall if not properly supported
and secured to the lifting device.
Component damage hazard. Be
careful not to damage the valve
or fittings on the cylinder while
removing it from the machine.
19 Install new cylinder, fittings, hoses and
pressure transducer.
Torque specifications
Solenoid valve, 2 position 2 way, N.C.
(schematic item N)
Coil nut
Pressure transducer
(schematic item R)
20 Remove the lifting device supporting the link
stack at the steer end of the machine.
Part No. 1309020GT
21 Connect the battery pack to the machine.
22 Press and hold the ground control scroll up
23 Pull out the red Emergency Stop button to the
24 Using the ground control menu buttons,
Note: The machine must be in Service Override
Mode to raise the platform. While in Service
Override Mode, only the GCON will operate with
limited functionality. The platform will raise a
predetermined amount of time and stop.
25 Raise the platform and rotate the safety arm
26 Fully lower the platform to the stowed
27 Calibrate the platform overload system. Refer
20 ft-lbs
27 Nm
5 ft-lbs
7 Nm
27 ft-lbs
37 Nm
GS ™ -30m • 32m • 30 • 32 • 46 • 55
Service and Repair Manual
Scissor Components
and scroll down buttons.
on position at the ground controls.
navigate to Service Override Mode. Select
Service Override Mode.
to the stowed position.
position.
to Repair Procedure How to Calibrate the
Platform Overload System.
147