Terex Genie GS-1330m Service And Repair Manual page 109

August 2021
45 Use a soft metal drift to tap the number
3 pivot pin (index #17) in the other direction.
Remove the number 3 outer arm (index #16)
from the battery pack side of the machine.
Bodily injury hazard. The
number 3 outer arm at the
battery pack side may become
unbalanced and fall if not
properly supported when
removed from the machine.
46 Remove the number 3 pivot pin (index #17)
from the non-steer end of the machine.
47 Attach a lifting strap from an overhead
supporting device to the lug on the rod end of
the lift cylinder for support. Do not apply any
lifting pressure.
48 Remove the pin retaining fasteners from the
lift cylinder rod-end pivot pin (index #5). Use a
soft metal drift to remove the pin.
Bodily injury hazard. The
cylinder may fall when the rod-
end pivot pin is removed if not
properly supported.
49 Lower the cylinder onto the number 1 inner
arm (index #9).
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
50 Attach a lifting strap from an overhead
supporting device to the number 3 inner arm
(index #15).
51 Remove the retaining fasteners from the
number 3 pivot pin (index #6) at the steer end.
Part No. 1309020GT
52 Use a soft metal drift to remove the number
53 Remove the cables from the number 2 cable
54 Remove the external snap rings and retaining
55 Remove the number 2 cable bridge mounting
56 Attach a lifting strap from an overhead
57 Use a soft metal drift to remove the number
58 Remove the retaining fasteners from the
59 Use a soft metal drift to tap the number
GS ™ -30m • 32m • 30 • 32 • 46 • 55
Service and Repair Manual
Scissor Components
3 pivot pin (index #6). Remove the number
3 inner arm (index #15) from the machine.
Bodily injury hazard. The
number 3 inner arm may
become unbalanced and fall if
not properly supported when
removed from the machine.
bridge and lay them off to the side.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
fasteners from the number 2 center pivot pin
(index #7) at the ground controls side.
fasteners and remove the cable bridge from
the machine.
supporting device to the number 2 outer arm
(index #19) at the ground controls side.
2 center pivot pin (index #7) at the ground
controls side.
number 2 pivot pin (index #20) at the non-
steer end of the machine.
2 pivot pin (index #20) halfway out at the non-
steer end of the machine. Remove the
number 2 outer arm (index #19) from the
ground controls side of the machine.
Bodily injury hazard. The
number 2 outer arm at the
ground controls side may
become unbalanced and fall if
not properly supported when
removed from the machine.
95