Terex Genie GS-1330m Service And Repair Manual page 134

Service and Repair Manual
Scissor Components
45 Remove the cables from the number 4A and
4B cable bridges and lay them off to the side.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
46 Disconnect the number 4A and 4B cable
bridges from the scissor linkset and remove
both cable bridges from the machine.
47 Attach a lifting strap from an overhead
supporting device to the lug of the rod end of
the upper lift cylinder.
48 Remove the retaining fasteners from the
upper lift cylinder rod end pivot pin (index #3).
49 Use a soft metal drift to remove the upper lift
cylinder rod end pivot pin (index #3) from the
machine.
Crushing hazard. The lift
cylinder will fall if not properly
supported when the pivot pin is
removed.
50 Lower the cylinder onto the linkset.
51 Attach a lifting strap from an overhead
supporting device to the number 4 outer arm
at the ground control side (index #20).
52 Remove the retaining fasteners from the
number 4 center pivot pin (index #5) at the
ground control side.
53 Place a rod through the number 4 center pivot
pin at the ground control side (index #5) and
twist to remove the pin.
54 Remove the retaining fasteners from the
number 4 pivot pin (index #21) at the non-
steer end.
120
55 Use a soft metal drift to remove the number
56 Attach a lifting strap from an overhead
57 Remove the retaining fasteners from the
58 Place a rod through the number 4 center pivot
59 Remove the number 4 outer arm (index #20)
60 Attach a lifting strap from an overhead
61 Remove the retaining fasteners from the
62 Use a soft metal drift to remove the number
GS ™ -30m • 32m • 30 • 32 • 46 • 55
4 pivot pin (index #21) from the non-steer end
of the machine. Remove the number 4 outer
arm at the ground control side (index #20)
from the machine.
Crushing hazard. The number
4 outer arm at the ground control
side (index #20) may become
unbalanced and fall if not
properly supported when
removed from the machine.
supporting device to the number 4 outer arm
at the battery side (index #20).
number 4 center pivot pin (index #5) at the
battery side.
pin at the battery side (index #5) and twist to
remove the pin.
from the machine.
Crushing hazard. The number
4 outer arm (index #20) may
become unbalanced and fall if
not properly supported when
removed from the machine.
supporting device to the number 4 inner arm
(index #19). Raise the arm to a vertical
position.
number 4 pivot pin at the steer end of the
machine (index #6).
4 pivot pin (index #6) from the steer end of the
machine. Remove the number 4 inner arm
(index #19) from the machine.
Crushing hazard. The number
4 inner arm (index #19) may
become unbalanced and fall if
not properly supported when
removed from the machine.
August 2021
Part No. 1309020GT