Terex Genie GS-1330m Service And Repair Manual page 127

August 2021
46 Remove the retaining fasteners from the
number 3 center pivot pin (index #4) at the
ground control side.
47 Place a rod through the number 3 center pivot
pin at the ground control side (index #4) and
twist to remove the pin.
48 Remove the retaining fasteners from the
number 3 pivot pin (index #17) at the non-
steer end.
49 Use a soft metal drift to remove the number
3 pivot pin (index #17) from the non-steer end
of the machine. Remove the number 3 outer
arm at the ground control side (index #16)
from the machine.
Crushing hazard. The number
3 outer arm at the ground control
side (index #16) may become
unbalanced and fall if not
properly supported when
removed from the machine.
50 Attach a lifting strap from an overhead
supporting device to the number 3 outer arm
at the battery side (index #16).
51 Remove the retaining fasteners from the
number 3 center pivot pin (index #4) at the
battery side.
52 Place a rod through the number 3 center pivot
pin at the battery side (index #4) and twist to
remove the pin.
53 Remove the number 3 outer arm (index #16)
from the machine.
Crushing hazard. The number
3 outer arm (index #16) may
become unbalanced and fall if
not properly supported when
removed from the machine.
54 Attach a lifting strap from an overhead
supporting device to the lug of the rod end of
the lift cylinder.
Part No. 1309020GT
55 Remove the retaining fasteners from the lift
56 Use a soft metal drift to remove the lift
57 Place a 4 x 4 x 10 inch / 10 x 10 x 25 cm
58 Lower the cylinder onto the block.
59 Attach a lifting strap from an overhead
60 Remove the retaining fasteners from the
61 Use a soft metal drift to remove the number
62 Remove the cables from the number 2A and
63 Disconnect the number 2A and 2B cable
GS ™ -30m • 32m • 30 • 32 • 46 • 55
Service and Repair Manual
Scissor Components
cylinder rod end pivot pin (index #5).
cylinder rod end pivot pin (index #5) from the
machine.
Crushing hazard. The lift
cylinder will fall if not properly
supported when the pivot pin is
removed.
block onto the number 1 inner arm cylinder
plate (index #10).
Bodily injury hazard. Keep
hands clear of moving parts
when lowering the cylinder.
supporting device to the number 3 inner arm
(index #15). Raise the arm to a vertical
position.
number 3 pivot pin at the steer end of the
machine (index #6).
3 pivot pin (index #6) from the steer end of the
machine. Remove the number 3 inner arm
(index #15) from the machine.
Crushing hazard. The number
3 inner arm (index #15) may
become unbalanced and fall if
not properly supported when the
pivot pin is removed.
2B cable bridge and lay them off to the side.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
bridges from the scissor linkset and remove
both cable bridges from the machine.
113