Scissor Assembly - Gs-1930, Gs-1932, Gs-1932 Xh - Terex Genie GS-1330m Service And Repair Manual

Service and Repair Manual
Scissor Components
9-4
Scissor Assembly - GS-1930,
GS-1932, GS-1932 XH
How to Disassemble the Scissor
Assembly
Bodily injury hazard. The
procedures in this section
require specific repair skills,
lifting equipment and a suitable
workshop. Attempting this
procedure without these skills
and tools could result in death or
serious injury and significant
component damage. Dealer
service is required.
Note: When removing a hose assembly or fitting,
the O-ring (if equipped) on the fitting and/or hose
end must be replaced. All connections must be
torqued to specification during installation. Refer to
Specifications, Hydraulic Hose and Fitting Torque
Specifications.
Note: After replacing the scissor assembly, the
platform overload system must be calibrated.
Refer to Repair Procedure, How to Calibrate the
Platform Overload System.
1 Turn the key switch to ground controls and
pull out the red Emergency Stop button to the
on position at both ground and platform
controls.
2 Raise the platform 7 to 9 feet / 2,1 to 2,8 m.
3 Lift the safety arm, move it to the center of the
scissor arm and rotate down to a vertical
position.
4 Lower the platform onto the safety arm.
Crushing hazard. Keep hands
clear of the safety arm when
lowering the platform.
92
5
6
7
8
9
10 Remove the fastener securing the platform
11 Remove the platform height sensor assembly
12 Remove the plastic nut securing the squeeze
13 Remove the squeeze connector from the
14 Remove the fasteners securing the large
15 Remove the large platform height sensor
GS ™ -30m • 32m • 30 • 32 • 46 • 55
At the ground controls, turn the key switch to
the off position and push in the red
Emergency Stop button to the off position.
Disconnect the battery pack from the
machine.
Electrocution/burn hazard.
Contact with electrically charged
circuits could result in death or
serious injury. Remove all rings,
watches and other jewelry.
Remove the fasteners securing the large
platform height sensor cover to the large
platform height sensor bracket.
Remove the platform height sensor cover.
Tag and disconnect the platform height
sensor from the platform height sensor
harness.
height sensor assembly to the number 1 inner
arm.
from the number 1 pivot pin.
connector to the large platform height sensor
bracket.
large platform height sensor bracket.
platform height sensor bracket to the number
1 inner arm pivot bracket.
bracket from the number 1 inner arm pivot
bracket.
August 2021
Part No. 1309020GT