Platform Components; Platform; Platform Extension - Terex Genie GR -12 Service Manual

Section 4 • Repair Procedures

Platform Components

2-1

Platform

How to Remove the Platform
1 Raise the platform approximately 1 foot / 30 cm.
2 Place support blocks between the platform and
the drive chassis. Lower the platform onto the
blocks.
Crushing hazard. Keep hands
clear when lowering the platform.
3 Turn the key switch to the off position and
disconnect the battery pack from the machine.
Electrocution/burn hazard. Contact
with electrically charged circuits
could result in death or serious
injury. Remove all rings, watches
and other jewelry.
5 Disconnect the platform controls from the
control cable at the platform. Remove the
platform controls from the platform and set the
controls to the side.
6 Carefully cut the cable ties securing the control
cable to the platform.
Component damage hazard. The
control cable can be damaged if
cut while removing the cable ties.
7 Remove the fasteners securing the junction
box bracket to the mast. Set the bracket and
fasteners to the side.
3 Attach a lifting strap of suitable capacity from
an overhead crane and center it around the
platform railing. Support the platform. Do not
apply any lifting pressure.
8 Remove the fasteners securing the platform
mount to the mast and set the fasteners to the
side. Remove the platform and mount from the
machine.
Crushing hazard. The platform
could become unbalanced and fall
if not properly supported when
removed from the machine.
4 - 12
2-2

Platform Extension

How to Remove the
Platform Extension
1 Turn the key switch to the off position.
2 Disconnect the battery pack from the machine.
3 Disconnect the platform controls from the
control cable at the platform, and remove the
platform controls from the platform. Set the
platform controls to the side.
4 Slide the extension deck forward until the holes
at the front of the extension deck are aligned
with the fasteners of the slide blocks, at the
front of the main deck.
5 Remove the fasteners securing the white slide
blocks to the main deck. Set the slide blocks
and the fasteners to the side.
6 Activate the foot release latch and slide the
extension platform out of the platform.
GR • QSR • QSW
September 2009
Electrocution/burn hazard. Contact
with electrically charged circuits
could result in death or serious
injury. Remove all rings, watches
and other jewelry.
Part No. 84700
REV C