Terex Genie GS-1330m Service And Repair Manual page 120

Service and Repair Manual
Scissor Components
43 Place a 4 x 4 x 10 inch / 10 x 10 x 25 cm
block onto the number 1 inner arm cylinder
plate (index #8).
44 Lower the cylinder onto the block.
Bodily injury hazard. Keep
hands clear of moving parts
when lowering the cylinder.
45 Attach a lifting strap from an overhead
supporting device to the number 3 inner arm
(index #10). Raise the arm to a vertical
position.
46 Remove the retaining fasteners from the
number 3 pivot pin at the steer end of the
machine (index #4).
47 Use a soft metal drift to remove the number
3 pivot pin (index #4) from the steer end of the
machine. Remove the number 3 inner arm
(index #10) from the machine.
Crushing hazard. The number
3 inner arm (index #10) may
become unbalanced and fall if
not properly supported when the
pivot pin is removed.
48 Remove the cables from the number 2A and
2B cable bridges and lay them off to the side.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
49 Disconnect the number 2A and 2B cable
bridges from the scissor linkset and remove
both cable bridges from the machine.
50 Attach a lifting strap from an overhead
supporting device to the number 2 outer arm
at the ground control side (index #14).
51 Remove the retaining fasteners from the
number 2 center pivot pin (index #5) at the
ground control side.
106
52 Place a rod through the number 2 center pivot
53 Remove the retaining fasteners from the
54 Use a soft metal drift to remove the number
55 Attach a lifting strap from an overhead
56 Remove the retaining fasteners from the
57 Place a rod through the number 2 center pivot
58 Remove the number 2 outer arm (index #14)
GS ™ -30m • 32m • 30 • 32 • 46 • 55
pin at the ground control side (index #5) and
twist to remove the pin.
number 2 pivot pin (index #15) at the non-
steer end.
2 pivot pin (index #15) from the non-steer end
of the machine. Remove the number 2 outer
arm at the ground control side (index #14)
from the machine.
The number 2 outer arm at the
ground control side (index #14)
may become unbalanced and
fall if not properly supported
when the pivot pin is removed.
supporting device to the number 2 outer arm
at the battery side (index #14).
number 2 center pivot pin (index #5) at the
battery side.
pin at the battery side (index #5) and twist to
remove the pin.
Crushing hazard. The number
2 outer arm (index #14) may
become unbalanced and fall if
not properly supported when the
pivot pin is removed.
from the machine.
Crushing hazard. The number
2 outer arm (index #14) may
become unbalanced and fall if
not properly supported when
removed from the machine.
August 2021
Part No. 1309020GT