Platform Components; Platform; How To Remove The Platform - Terex GS90D-4695 Service And Repair Manual

December 2023
2-1

Platform

How to R emove the Pl atform

How to Remove the Platform

Bodily injury hazard. The
procedures in this section
require specific repair skills,
lifting equipment and a suitable
workshop. Attempting this
procedure without these skills
and tools could result in death or
serious injury and significant
component damage. Dealer
service is required.
Note: Perform this procedure with the platform in
the stowed position and the platform extension
deck(s) fully retracted and locked in position.
1 Start the engine from the ground controls and
raise the platform approximately 18 feet /
5.5 m from the ground.
2 Release the safety arm latch, lift the safety
arm and rotate to a vertical position. Lock the
safety arm in position.
Note: Be sure that the safety arm is locked in the
vertical position.
3 Lower the platform onto the safety arm. Turn
the machine off.
Crushing hazard. Keep hands
clear of the safety arm when
lowering the platform.
Component damage hazard.
The link set cross tube can be
damaged if excessive force is
applied. Do not continue to
lower the platform after the
safety arm makes contact with
the cross tube.
Part No. 1325652GT
4
5
6
7
8
9
10 Tag and disconnect the platform controls from
11 Remove the platform control box from the
12 Remove the mounting fasteners that hold the
13 Lay the platform controls wiring off to the side.
14 Remove the AC power to platform outlet
GS -3390 • GS -4390 • GS
™ ™
Service and Repair Manual

Platform Components

Cut the zip ties that secure the power to
platform wiring to the bottom of the platform.
Component damage hazard. Be
sure not to cut the power to
platform wiring.
Cut the zip ties that secure the platform
controls wiring to the bottom of the platform.
Component damage hazard. Be
sure not to cut the power to
platform wiring.
Start the engine from the ground controls.
Raise the platform slightly and return the
safety arm to the stowed position.
Lower the platform to the stowed position.
Turn the machine off.
Locate the quick disconnect for the platform
controls under the platform at the steer end of
the machine.
the control cable at the steer end of the
machine.
platform and lay it off to the side.
platform controls quick disconnect plug to the
platform.
Component damage hazard.
The platform controls wiring
can be damaged if it is
kinked or pinched.
bracket mounting fasteners.
-5390
™
21