Loading Or Updating Machine Software - Terex Genie GS-1330m Service And Repair Manual

Service and Repair Manual
Ground Controls
2-3
Loading or Updating Machine
Software
Note: Before updating the machine software, open
a web browser and navigate to the following
location for the Genie Machine Software Download
portal, http://firmware.genielift.com. Perform a
search by applying the appropriate filters and
download the machine software.
Note: There are two procedures available to
update the machine software. These are
Bootloader Mode and Machine Application
Mode.
Bootloader Mode: The Bootloader mode is only
available with the key switch in the GCON
position. It allows the user to update or reinstall the
machine software by directing the system into the
Bootloader.
Choose this mode if the GCON ECM is not
opertaing correctly.
Machine Application Mode: The machine
Application mode is available with the key switch
in the GCON or PCON position. This mode of
machine software update requires the user to
enter the Machine Service Tool.
Choose this mode if the machine is operating
correctly and you are updating the machine
software.
26
Bootloader Mode
1
Note: Some models will require opening the
ground control box to access the GCON.
2
3
4
GS ™ -30m • 32m • 30 • 32 • 46 • 55
Open the GCON compartment.
Turn the key switch to the ground controls
position and pull out the red Emergency Stop
button to the on position at the platform
controls.
At the ground controls, press and hold the
Enter and Escape buttons.
1 LCD display
2 enter button
3 escape button
Pull out the red Emergency Stop button to the
on position at the ground controls.
Result: The ground controls LCD display will
show the following:
August 2021
Part No. 1309020GT