Scissor Arm Wear Pads; How To Replace The Scissor Arm Wear Pad - Gs-1432M, Gs-1932M, Gs-1932M Lite, Gs-1932M Xh - Terex Genie GS-1330m Service And Repair Manual

August 2021
9-11

Scissor Arm Wear Pads

How to Replace the Scissor Arm How to Re place the Scissor Ar m We ar Pa d - GS-14 32m , GS- 1932 m, GS-19 32m Lite, GS-1 932 m XH
Wear Pad - GS-1432m, GS-1932m,
GS-1932m Lite, GS-1932m XH
1 Turn the key switch to ground control and pull
out the red Emergency Stop button to the on
position at both ground and platform controls.
2 Raise the platform 7 to 9 feet / 2,1 to 2,8 m.
3 Raise the safety arm from the drive chassis to
a vertical position.
4 Lower the platform onto the safety arm.
Crushing hazard. Keep hands
clear of the safety arm when
lowering the platform.
5 At the ground controls, turn the key switch to
the off position and push in the red
Emergency Stop button to the off position.
6 Disconnect the battery pack from the
machine.
Electrocution/burn hazard.
Contact with electrically charged
circuits could result in death or
serious injury. Remove all rings,
watches and other jewelry.
7 Remove the fasteners securing the platform
height sensor cover to the chassis.
8 Remove the platform height sensor cover.
9 Tag and disconnect the platform height
sensor from the platform height sensor
harness.
Part No. 1309020GT
10 Remove the fasteners securing the platform
11 Remove the fasteners securing the platform
12 Connect the battery pack to the machine.
13 Turn the key switch to ground controls.
14 Press and hold the ground control scroll up
15 Pull out the red Emergency Stop button to the
16 Using the ground control menu buttons,
17 Raise the platform and rotate the safety arm
18 Fully lower the platform to the stowed
19 Remove the platform. Refer to Repair
20 Remove the pins, shims and snap rings from
21 Attach a lifting strap from an overhead
22 Replace the wear pads.
GS ™ -30m • 32m • 30 • 32 • 46 • 55
Service and Repair Manual
Scissor Components
height sensor short arm cover to the number
1 inner arm.
height sensor to the chassis. Remove the
sensor.
and scroll down buttons.
on position at the ground controls.
navigate to Service Override Mode. Select
Service Override Mode.
to the stowed position.
position.
Procedure, How to Remove the Platform.
the number 1 inner arm at the steer end of the
machine.
supporting device to the steer end of scissor
assembly.
Crushing hazard. The scissor
assembly will fall if not properly
supported when removed from
the drive chassis.
139