Terex Genie GS-1330m Service And Repair Manual page 119

August 2021
24 Remove the platform. Refer to Repair
Procedure, How to Remove the Platform.
25 Support and secure the entry ladder to an
appropriate lifting device.
26 Remove the fasteners from the entry ladder
and remove the entry ladder from the
machine.
Crushing hazard. The entry
ladder will fall if not properly
supported and secured to the
lifting device.
27 Remove the cables from the number 3 cable
bridge and lay them off to the side.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
28 Disconnect the number 3 cable bridge from
the number 3 outer arm (index #11) and
remove the cable bridge from the machine.
29 Remove the retaining fasteners from the
number 4 pivot pin (index #1).
30 Use a soft metal drift to remove the number
4 pivot pin (index #1). Remove the platform
mount bracket from the machine.
31 Attach a lifting strap from an overhead
supporting device to the number 3 outer arm
at the ground control side (index #11).
32 Remove the retaining fasteners from the
number 3 center pivot pin (index #2) at the
ground control side.
33 Place a rod through the number 3 center pivot
pin at the ground control side (index #2) and
twist to remove the pin.
34 Remove the retaining fasteners from the
number 3 pivot pin (index #12) at the non-
steer end.
Part No. 1309020GT
35 Use a soft metal drift to remove the number
36 Attach a lifting strap from an overhead
37 Remove the retaining fasteners from the
38 Place a rod through the number 3 center pivot
39 Remove the number 3 outer arm (index #11)
40 Attach a lifting strap from an overhead
41 Remove the retaining fasteners from the lift
42 Use a soft metal drift to remove the lift
GS ™ -30m • 32m • 30 • 32 • 46 • 55
Service and Repair Manual
Scissor Components
3 pivot pin (index #12) from the non-steer end
of the machine. Remove the number 3 outer
arm at the ground control side (index #11)
from the machine.
Crushing hazard. The number
3 outer arm at the ground control
side (index #11) may become
unbalanced and fall if not
properly supported when
removed from the machine.
supporting device to the number 3 outer arm
at the battery side (index #11).
number 3 center pivot pin (index #2) at the
battery side.
pin at the battery side (index #2) and twist to
remove the pin.
from the machine.
Crushing hazard. The number
3 outer arm (index #11) may
become unbalanced and fall if
not properly supported when
removed from the machine.
supporting device to the lug of the rod end of
the lift cylinder.
cylinder rod end pivot pin (index #3).
cylinder rod end pivot pin (index #3) from the
machine.
Crushing hazard. The lift
cylinder will fall if not properly
supported when the pivot pin is
removed.
105