Table of Contents
Advertisement
Service and Repair Manual
Turntable Rotation Components
9-1
Turntable Rotation Assembly
How to Remove a Turntable
Rotation Assembly
Note: When removing a hose assembly or fitting,
the O-ring (if equipped) on the fitting and/or hose
end must be replaced. All connections must be
torqued to specification during installation. Refer to
Specifications, Hydraulic Hose and Fitting Torque
Specifications.
Note: Perform this procedure with the primary boom
between the circle-end tires and with the machine
on a firm, level surface.
1
Secure the turntable from rotating with the
turntable rotation lock pin.
2
Remove the ground controls side fixed
turntable cover.
3
Tag, disconnect the hydraulic hoses from the
turntable rotation motor. Cap the fittings on the
motor.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
4
Attach a lifting strap from an overhead crane or
other suitable lifting device to the lifting eye on
the turntable rotation assembly.
130
5
Remove the drive hub mounting bolts and
remove the turntable rotation assembly from
the machine.
6
Repeat steps 3 through 5 for the other
turntable rotation assembly.
Note: When installing a turntable rotation assembly,
the rotation gear backlash must be adjusted. Refer
to Repair Procedure, Adjust the Turntable Rotation
Gear Backlash.
SX-180
December 2018
Tip-over hazard. If the turntable
rotation lock pin is not properly
installed, machine stability is
compromised and the machine
could tip over when the drive hub
is removed from the machine,
which could result in death or
serious injury.
Crushing hazard. The drive hub
could become unbalanced and
fall if not properly supported by an
overhead crane or lifting device
when removed from the machine.
Part No. 1268497
Advertisement
Table of Contents
