Scissor Assembly, Gs-1930 And Gs-1932 - Terex Genie GS-1530 Service Manual

October 2008
REV C
3-2
Scissor Assembly,
GS-1930 and GS-1932
How to Disassemble the
Scissor Assembly,
GS-1930 and GS-1932
Bodily injury hazard. The
procedures in this section require
specific repair skills, lifting
equipment and a suitable
workshop. Attempting this
procedure without these skills and
tools could result in death or
serious injury and significant
component damage. Dealer
service is required.
Note: When removing a hose assembly or fitting,
the O-ring on the fitting and/or hose end must be
replaced and then torqued to specification during
installation. Refer to Section 2, Hydraulic Hose and
Fitting Torque Specifications.
1 Remove the platform. See 2-1, How to Remove
the Platform.
2 Remove the cables from the number 4 outer
arm (index #13) at the ground controls side.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
Part No. 96316
3 Remove the cables from the number 4 cable
bridge and lay them off to the side.
4 Attach a lifting strap from an overhead crane to
the number 4 outer arm (index #13).
5 Remove the external snap rings and retaining
fasteners from the number 4 center pivot pins
(index #2).
GS-30 • GS-32 • GS-46
Section 4 • Repair Procedures
SCISSOR COMPONENTS
GS-1930
GS-1932
Cable bridge legend
a cable bridge 4
b cable bridge 3
c cable bridge 2
d cable bridge 1
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
a
b
c
d
4 - 25