Confirmation Of Settings - Furuno FS-1562 Manual

2.2 Confirmation of settings

To confirm settings, press [RCL] [9] [9] [9] [9] and [ENT] in this order.
Then press [ENT] key successively.
System setting for GMDSS
FS-5000)
System channel:9982 (A.BK relay or R.ANT) ---- [1]: YES
Note)
Tx/Rx ANT
ANT BK Relay
FS-8000)
9913:System Delay
9917:50 ohm BK Relay
Tx/Rx ANT
9917: 0 (ON/OFF)
"BFO" setting frequency
The DSC and NBDP are connected, the BFO frequency should be set to 1700 Hz.
1700 Hz;
9913:System Delay
9917:50 ohm BK Relay
*The 50 ohm BK is installed the TX FIL board.
Tx ANT
AT-5000
or
Tx Rx
FS-5000T
*The 50 ohm BK is installed the COMBINER board.
Tx ANT
AT-5000
or
Tx/Rx
FS-8000T
[BFO] 1700 [ENT]
10 ms
1:ON (Permanently)
Rx ANT
AT-5000
Tx Rx
FS-5000T
10 ms
ON or OFF (depend on installation)
Rx ANT
AT-5000
Tx Rx
FS-8000T
9917: 1 (ON)
A3-6
FS-5000/8000