Led Status - Furuno FS-1562 Manual

3.8.2 Connection to Internet service
If a number of the Internet service provider is available, access to an Internet web site.
1. Complete the Dial-up Networking setting; HSD modem and TCP/IC protocol.
2. Make sure that FELCOM 82 is in stand-by condition.
3. Call Service Provider

3.9 LED status

The LED status is tabulated in this section.
3.9.1 RF CON Board (16P0181)
Parts No. Color
CR5 GRN
CR6 GRN
CR7 RED
CR8 RED
CR9 RED
SNY UNLOCK IND
CR7: TX
CR8: RX1
CR9: RX2
Status Item
Blink FSK RX
Monitor
(Looks
like ON)
On TX ON
Off TX PLL unlock
Off RX PLL1
unlock
(815 MHz)
Off RX PLL2
unlock
(730 MHz)
H3-40
Remarks
This LES is used to check the
communication between the antenna
and the comm. units. The brightness of
the LED depends on FSK data from the
antenna unit.
This LED is on during TX and off during
RX.
This LED is on for a while at power up.
After the CPU board assigns the
channel to be use, LED goes off. The
LED should not be on continuously.
This LED is on for a while at power up.
After the CPU board assigns the
channel to be use, LED goes off. The
LED should not be on continuously.
This LED is on for a while at power up.
After the CPU board assigns the
channel to be use, LED goes off. The
LED should not be on continuously.
FELCOM 82
CR5: FSK Rx Motor
CR6: TX ON