Channel Programming - Furuno FS-1562 Manual

3. Channel Programming

System channel: 9998 muse be set "0", refer to section "2. System settings".
The FS-75/2550 can store up to 200 user channels,
Band(MHz)
0
1
2
3
4
6
8
12
16
18
22
25
Procedure
1. While pressing and holding down the [CH] key, turn the power on.
2. Select the system channel 9999 by operating the FREQ/CH encoder.
3. Press the [CH] [7] [5] and [ENT] keys in this order. (Password)
4. Select the system channel 9998.
5. Press the [CH] [0] and [ENT] keys to enable channel programming.
6. Select an RX channel to be programmed by operating the FREQ/CH encoder.
Operating the FREQ/CH encoder changes the display as below.
9999
9998
7. Select the emission mode with the [MODE] key.
8. To enter an RX frequency, press the [Freq] key and enter a frequency with the
number keys, then press the [ENT] key.
9. Select a TX channel of the same channel as RX with the FREQ/CH encoder.
Channel
1-10
1-10
1-10
1-10
1-20
1-20
1-20
1-20
1-20
1-20
1-20
1-20
Band
0 - 01
0.00
R
MEMO
J3E
0-01 R 0-01 T ------
------ 9900
A2-7
See the table below.
Channel
Frequency
25-20 R
25-20 T
FS-75/2550