Updating Modem Program With Ib-581 - Furuno FS-1562 Manual

9.3 Updating MODEM program with IB-581

1. Connect the IB-581 to the DSC-60.
2. Turn on the IB-581, but do not turned on the DSC-60.
3. Terminate the terminal program.
When using IB-581 for DP-6, FELCOM 12/81, while press and holding down [Alt]
and [Fn], press [F2]. For example, A:\DP10\TERMINAL appears on the DP-6
terminal.
When using IB-581 for FELCOM 11, press [F1] and [8] in order.
4. Insert the program floppy disk in the slot.
5. Type B: and press [Enter]. The prompt B:\> appears.
6. Type "UPMODEM" and press [Enter]. The following message appears.
Program upload utility Version 6.21
Copyright(c) FURUNO ELECTRIC CO., LTD.1997,1998,1999 (T.K)
uppg infile 1 infile 2 p1 p2 p4 p5
p1:Deletion waiting time.
p2:Waiting time to write.
p3:Password output interval.
p4:ID number.(1,2...)
p5:Poer number.(1,2...)
Erase Wait:osec
Wait:o
Wait counter=100
Port no.=1
TARGET POWER ON.
7. Turn on the DSC-60.
The message "Now Loading" appears on the DSC screen. The picture on the IB-581
runs.
8. Wait for about 5 minutes.
9. The DOS prompt appears after the message "Finish version up."
10. Turn off the DSC-60, disconnect the IB-581 and turn on the DSC-60 again.
11. Press [3/TEST/DEF] to perform the self test and confirm the program has been
updated.
*** Checking program Version, refer to section "6.Self test". ***
B4-21
DSC60