Data Test - Furuno FS-1562 Manual

3.7 9.6k Data test
This section describes how to test 9.6k data (MSD) function. The COM port on the PC
is connected to the MSD port on the FELCOM 82 communication unit.
3.7.1 Using AT command
To check communication between the PC and the communication unit;
1. Double click on the Modem icon in the Control panel window.
2. Select "standard 9600 bps modem."
3. Select communications port, or COM port to be used for 9.6k data
communication.
4. Start HyperTerminal from the Windows 95/98 start menu.
5. In the HyperTerminal window, type AT, followed by the [Return] key. The
FELCOM should reply with "OK." If it does not, check the cable and try again.
If there is still no response, check the COM Properties window.
Bits per second: 9600
Data bits: 8
Parity: None
Stop bits: 1
Flow control: Hardware
6. Type AT&H, followed by [Enter] key. The command list should be displayed.
3.7.2 Connection to Internet provider
If a number of the Internet Service Provider is available, try to access to an Internet web
site. To do so,
1. Complete the Dial-up Networking setting; Standard 9600bps modem and
TCP/IC protocol.
2. Make sure that FELCOM 82 is in stand-by condition.
3. Call Service Provider
H3-37
FELCOM 82