Setting For The Connection With Fs-75/1562/5000 And Dp-6 - Furuno FS-1562 Manual

3.2 Setting for the connection with FS-75/1562/5000 and DP-6

TX/RX control data exchange between Furuno radio units is made normally by MIF
protocol through the RS-232C connections with factory-default setting.
[RT]
#2-SD
#3-RD
DSC-60
[REM-B]
[NBDP]
DP-6
#2-SD
#3-RD
Connection with FS-5000 and DP-6
The DIP switches on CONTROL/MODEM board of DSC-60 are set as follows:
RT: S4 (Selection of data format for the communication with RT)
- S4-1 and 2 : ON (RS-232C)
- S4-3 and 4 : OFF (RS-232C)
NBDP: S3 (Selection of data format for the communication with NBDP)
- S3-1 and 2 : ON (RS-232C)
- S3-3 and 4 : OFF (RS-232C)
Note) Related settings
Pressing [#/SETUP] key reveals "Setup menu" screen. Select SYSTEM, and set RT
PORT and NBDP PORT.
- RT PORT
- NBDP PORT ->>> ON
Furthermore, priority setting must be made on FS-75/1562:Ver.07 and after.
Not necessary on FS-5000.
FS-75/1562 Set to setting No.9928:1
Priority
0: Main unit takes priority.
1
2
3 DSC other than distress
4
5
6
[REM-1/2/3]
FS-5000C
[REM-A]
[REM-1/2/3]
->>> MIF
FS-75/1562
DSC Distress alert
2182kHz (Main unit)
Remote TEL (DSC)
NBDP
Main unit
[RT]
#2-SD
#3-RD
DSC-60
[NBDP]
#2-SD
#3-RD
Connection with FS-75/1562 and DP-6
Setting of 9928
1: Remote control takes priority.
DSC Distress alert
DSC other than distress
Remote TEL (DSC)
NBDP
2182kHz (Main unit)
Main unit
B4-7
[REM]
DB-120
[REM-B] [REM-A]
DP-6
DSC60
REM-A
PCB
FS-75/1562