Gyro Setting - Furuno FS-1562 Manual

2.4 Gyro setting

The communication unit has a built-in gyro I/F board, 64P1106, identical to the one
used in Furuno large radars. The board must be set up according to the type of the gyro
connected.
GYRO I/F Board
(64P1106)
2.4.1 Switch and Jumper Setting
The default settings are shown in shaded cell of each setting item. (Turn off the unit to
change the settings.)
1) Gyro type
Gyro Type
AC synchro
DC synchro
DC step
Full-wave pulsating current
Half-wave pulsating current
2) Frequency
Frequency
50/60 Hz
400 Hz
500 Hz
DC
SW1 #4
OFF
OFF
ON
OFF
ON
SW1 #7 SW1 #8
OFF OFF
ON OFF
OFF ON
ON ON
H3-6
Default setting
-Type
-Frequency
-Rotor Voltage
-Stator Voltage
-Gear Ratio
-Supplied Power : 30 VAC to 135 VAC
SW1 #5 SW1 #6
OFF OFF
OFF OFF
OFF OFF
ON OFF
ON OFF
Remarks
AC synchro pulsating current
AC synchro pulsating current
AC synchro pulsating current
DC synchro, DC step
FELCOM 82
: AC synchro
: 50/60 Hz
: 60 VAC to 135 VAC
: 60 VAC to 135 VAC
: 360X
JP1
#1, #2, #3
#2, #3, #4
#4, #5, #6
#4, #5, #6
#4, #5, #6