Furuno FS-1562 Manual page 55

9917
Used if installation contains a receiving antenna or ANT BK RELAY board (in
antenna coupler). For high speed switching between receiving and
transmitting
(for example, telex) set to "1." Then, TX delay time (system setting 9913) is
shortened to "10ms".
9919
For control unit priority, select the same setting numbers for both control units.
*To give priority to No. 1 Control Unit;
No.1 Control Unit: Setting "1"
No.2 Control Unit: Setting "1"
9923
Setting No.
"0"(Enable)
"1"(Disable)
"2"
(Short Cap.)
9928
For 1988 SOLAS Convention ships (GMDSS) set this item to "1." Then, minimum
output power is automatically set at 60W (power data -- MF:115, HF:110), except
for minimum power data already stored into user channel.
9930 - 9932
MIF Furuno Multi Interface for Radio communication. Selected when DP-6,
DSC-6 is connected.
TBUS Selected for equipment made by 'Thrane & Thrane A/S" of Denmark. If
TBUS data is used, it is not necessary to connect TXD/RXD lines.
9934 – 9936
If you wish to change the class of emission only while the selcall is transmitted
and to restore it automatically to previous status after transmission, set the channel
Nos. 9934 - 9936 and 9937 to "0" (No change) and "2" (AM), respectively.
EX) Selcall is connected REM 1, set to system channel "9934" to "0" and
"9937" to "2"..
Contents
Dummy load can be switched
by DUMMY key.
DUMMY key is not
operative.
Shortening capacitor
automatically turns on in the
range set by 9924/9925.
Further, DUMMY key is
allowed to turn on/off
shortening capacitor.
*To give priority to No. 2 Control Unit;
No.1 Control Unit : Setting "2"
No.2 Control Unit : Setting "2"
LCD Indication
DUMMY
---
S.CAP(Shorten-ing
capacitor)
A3-8
FS-5000/8000
Remarks
With DUMMY LOAD
PCB.
Without DUMMY
LOAD PCB
With modified
DUMMY LOAD PCB