Furuno FS-1562 Manual page 376

Error Message
Call failed, LES congested (no channel unit). (5713)
Call failed, terrestrial circuits congested. (5201)
Call failed, LES congested (no channel and no circuit). (5202)
Call failed, LES congested (no channel). (5457)
Call failed, LES congested (no time-slot). (5458)
Call failed, terrestrial party busy. (7953)
Call failed, terrestrial circuit failure. (8033)
Call failed, terrestrial party cleared before MES
connection.(8034)
Call failed, set-up between LES and terrestrial circuits failed.
(7265)
Call failed, MES not authorised at this LES. (5537)
Call failed, Distress call in progress. (0062)
Call failed, MES busy. (0060)
Call failed, MES terminal not enabled. (0061)
Call failed, antenna circuit abnormality. (0032)
Call failed, no channel assignment received from LES. (0033)
Call failed, invalid power level assignment. (0034)
Call failed, RX DEMOD circuit abnormality. (0035)
Call failed, TX MOD circuit abnormality. (0036)
Call failed, TX-RF circuit abnormality. (0038)
Call failed, Selectively cleared by LES. (0039)
Call failed, MES unable to sync. to NCSA in time. (0041)
Call failed. (0042)
* = Another error message accompanies these messages and is printed
out. Trouble can be determined from the printout.
Note 1: Number in parentheses is error message number.
Note 2: Wait 30 seconds before calling again.
Call failure error message (con't)
• Line is busy.
• Line trouble.
Ship's answerback code not
properly entered.
Call of higher priority in
progress.
MES not ready for
communications.
MES not ready for
communications.
Equipment trouble*
H3-47
FELCOM 82
Reason
Try again a little
while later.
Checking
OID/DID
Try again a little
while later.
Try again a little
while later.
Setting: Incoming
only OFF
Remedy