Terminal Unit; Section K1; How To Quit Programs - Furuno FS-1562 Manual

AR-B1374

1. How to Quit Programs

When updating the program of each terminal unit, quit the program, and then switch to the
screen in which the PC-DOS prompt such as "A:¥-----" is displayed. The table below
summarizes how to quit the terminal program for each terminal.
Terminal
unit
DP-6
Note)With the version Ver-15 or earlier
Main
unit
FELCOM 11
FELCOM 12 [Alt]+[Fn]=>[F2]=>YES=>[Enter]
FELCOM 81 [Alt]+[Fn]=>[F2]=>YES=>[Enter]
For example, to quit the terminal program of FELCOM-12:
- Press [F2] key while pressing [Alt] and [Fn] keys.
- A message, "OK to quit system Yes/No", will appear. Then, move the cursor to "Y",
and press [Enter] key.
- Then, the prompt, "A:¥FELCOM12>", will appear on the screen.
To update the terminal program, B-drive (B:¥>) is used. To change from A-drive to B
drive,
- press [B],[:], and [Enter] keys successively.
Then, the prompt, "B:¥>", will appear on the screen.
Type "installation command", then press [Enter] key. (See above table; installation
command.)
Note) Drives of IB-581 are:
Changing to PCDOS
[Alt]+[Fn]=>[F2]
[Fn]+[F2]
[F1] =>[8]
A drive : Flash ROMs of IB-581
B drive : Floppy disk
Section K1. IB-581
Display
A:¥DP10¥
TERMINAL>
A:¥
FELCOM11>
A:¥
FELCOM12>
A:¥>
K1-1
CPU card
How to confirm Installation
program version command
B:¥>install
[F6]=>Self test
B:¥>nbdpinst
[F1]=>nbdp.exe
Confirm at
B:¥>ibinst
program starting
Ver03:
B:¥>ibinst
[Alt]+[Fn]=[F1]
[Alt]+[Fn]=[F1] B:¥>ibinst