Furuno FS-1562 Manual page 280

The default settings are shown in a screened cell of each setting item.
Setting item
Unit
SW Panel
SW1
SW Panel
SW2
IB-680
SW Panel
SW3
SW Panel
SW4
SW Panel
SW5
Date rate SW
Reference: IB-680)
Registering, Deleting Subscriber Number
Register subscriber number as follows with the No.1 telephone. The subscriber number
may contain 20 digits (*,# cannot be registered). The number can be confirmed by
printing the status display.
1. Pick up the handset of the No.1 telephone and confirm dial tone.
2. Dial subscriber's No. as follows;
*51* aaa
Deleting subscriber number
Dial [*] [5] [1] [*] [#].
Function
OFF: Direct call
Automatic call
ON: Address call
OFF: RS-449
Terminal
Interface
ON: RS-232C
Automatic data
rate switching
ON: YES
Command OFF: HDCL
format
ON: BSC
Character OFF: 8 bit/no parity
format
ON: 7 bit/odd parity
Data rate
00 bb xxxxxxxxx
H1-4
Setting
No.1 TEL:
- Register the TEL number: *51* LES
00 Country code xxxxxxx #
- Clear the registered number: *51*#
Call start with reception of DTR
signal from HSD terminal.
Interface with HSD terminal.
Never use both RS-232C and RS-449
terminal on the HSD modem at the
time.
OFF: NO
- High level data link control
- Binary synchronous communication
64k
56k is for USA ISDN circuit
56k
#
subscriber number
Country code
Automatic Dialing
Land Earth Station (LES)
Prefix for HSD call
Note
RS-449:D-SUB 37pin
RS-232C: D-SUB 25pin
FELCOM 80