Changing Id (Mmsi) Number - Furuno FS-1562 Manual

6. Changing ID (MMSI) number

Refer to section "7. Clearing Contents of S-RAM and EEROM"
Procedures
1. Press the NMI switch S1 on the CONTROL board with the unit turned on.
2. Since the power is automatically cut off, turn the power on.
3. The screen should look something like this:
4. Select "EEROM" and press the [ENT] key to clear data on the EEROM.
5. Since the power is automatically cut off, turn the power on again.
The initial setting display appears.
(Refer to section "3.1 Initial settings")
6. Enter own ship's ID (MMSI), data format of navigator (NMEA or CIF), DMC-5
connection, DP-5/6 connection, Installation type, Tx timing and AF line output level.
Clear <Do not clear>
NO RAM1 RAM2 EEROM
TEST
B2-8
(Ver-1.05 and after)
. . . .
DSC-6