Table of Contents
Advertisement
Installation/connection
6.3 SIMOCRANE CenSOR for an outdoor crane
Install the reflector on the load suspension device of the outdoor crane
NOTICE
Install the reflector properly
Improper installation will damage the reflector.
Note
The reflector must be easily visible from above / maximum skew of the reflector
• The reflector must be clearly visible vertically from above and must not be hidden by
structural elements.
• Install the reflector such that it is skewed by a maximum of 2 degrees in relation to the camera
when in the zero position (without skew of the load suspension device).
The maximum measurable rotation angle is ± 15°. A larger skew would prevent the camera
from recognizing the pattern of the reflector.
• Install the reflector on the load suspension device as shown in the "reflector installation
drawing".
Figure 6-6
• Bolt the reflector to the mounting points provided on the load suspension device using four
M8 bolts.
Details concerning the dimensions are provided in the documents supplied.
44
≤
Reflector installation drawing
SIMOCRANE CenSOR
Operating Instructions, 07/2021
Advertisement
Table of Contents
