Parameterization
8.4 Settings
Internal lamp / External lamp
Note
Changes to connected lamp / connection of a different lamp:
Programs no longer executable
Note:
If you subsequently change the parameters of a selected lamp or connect a different lamp, all
programs that use these lamps (internal or external) are marked as non-executable.
In order to use a non-executable program again, you must check the exposure settings and save
the program again.
Note
Internal lamp
The internal lamp is not relevant for SIMOCRANE CenSOR.
Table 8-26
Internal lamp / External lamp
Parameter
Possible values
Supply over PoE or
☐ / ☑
CM
Lamp
Internal
•
Auto (<article num‐
ber>)
•
6GF3440-8DA11
•
6GF3440-8DA21
•
6GF3440-8DA41
•
Other
•
None
External
•
None
•
Other
•
<Article number> of
external lamp
Product name
--
Flash
☐ / ☑
Permanent light
☐ / ☑
Polarized
☐ / ☑
Main beam
☐ / ☑
Unpolarized
☐ / ☑
98
Default
Description
☐
Not relevant for SIMOCRANE CenSOR
Auto (<article num‐
ber>)
Not relevant for SIMOCRANE CenSOR
Other
•
•
•
--
In this input box, you can assign a name to the lamp.
Possible values: Letters, numbers and ASCII special
characters. Maximum of 255 characters.
--
Not relevant for SIMOCRANE CenSOR
--
--
--
--
Select "None" if you do not want to use an ex‐
ternal lamp.
For the "Indoor" version, select:
6GF3400-0LT01-7BA1
For the "Outdoor" version, select: "Other" and
leave the additional lamp parameters at the de‐
fault values (see Figure 8-12 Options (Page 97))
Operating Instructions, 07/2021
SIMOCRANE CenSOR