Table of Contents
Advertisement
Firmware update
Use this function to update the firmware. Select the required update file (.sfw) and click "Start
update".
Note
The DISA bit must not be set during the firmware update
Make sure that the DISA bit is not set during the firmware update. This prevents an automation
system from changing the camera to "RUN" mode.
For more detailed information, refer to the displayed HTML page.
Note
Prior to the firmware update: Saving settings and programs
All settings and programs are lost during the firmware update. Make sure that you save all
settings and programs before running an update.
Following a prompt for confirmation, the camera restarts and boots in update mode. The camera
retains the IP address that it had when the function was activated. If applicable, the "DHCP" IP
mode is disabled for the duration of the update.
For more detailed information, refer to the displayed HTML page.
Factory settings
Use this function to reset the camera to the factory settings. All parameters will be reset to their
default values. All stored programs will also be deleted.
8.5.3
Adapt
In the "Adapt" menu, you can show hidden dialogs or hide dialogs automatically. Dialogs inform
you, for example, that changes have been executed successfully. In these dialogs, you have the
option of hiding the display of dialogs in the future. You can use this menu to reset these settings.
Hidden dialogs
Table 8-41
Button
All
Program
Verification
Settings
SIMOCRANE CenSOR
Operating Instructions, 07/2021
Hidden dialogs
Description
Click this button to display all the hidden dialogs.
Click this button to display all the hidden dialogs in the "Program" menu.
Click this button to display all the hidden dialogs in the "Verification" menu.
Click this button to display all the hidden dialogs in the "Settings" menu.
Parameterization
8.5 Device
117
Advertisement
Table of Contents
