• Install the reflector on the load suspension device as shown in the "reflector installation
drawing".
Figure 6-3
• Bolt the reflector to the mounting points provided on the load suspension device using the
M8 bolts.
Details concerning the dimensions are provided in the documents supplied, see Dimension
drawings (Page 141).
6.2.2
Connect components on the indoor crane
Note
Use a regulated switched-mode power supply
Use a regulated switched-mode power supply: 24 V/at least 2 A, surge-proof.
Next, connect the SIMOCRANE CenSOR components.
SIMOCRANE CenSOR
Operating Instructions, 07/2021
≤
Reflector installation drawing
Installation/connection
6.2 SIMOCRANE CenSOR for an indoor crane
39