Table of Contents
Advertisement
Risk of falling SIMOCRANE CenSOR components
All screwed joints are equipped with suitable screw locks to safely prevent SIMOCRANE CenSOR
components from falling down after installation.
• Always use these screw locks for installation.
• The screw locks may not be disabled or removed.
NOTICE
Protect the stainless steel housing against direct solar radiation
The specified temperature range of max. +50 °C can only be achieved if the stainless steel
housing is protected against direct solar radiation.
During installation, make sure that suitable protection is available.
Note
Install the protective camera housing vertically
Install the protective camera housing on the trolley such that the housing is positioned vertically
above the reflector that is attached to the load suspension device.
The glass screen of the housing must point downwards.
Note
Install the protective camera housing according to the direction of movement of the trolley
During the installation, observe the marking on the protective camera housing that indicates the
direction of movement of the trolley. Install the protective camera housing such that the arrow
points in the direction of movement of the trolley.
Due to the resolution of the installed imaging chip, the field of view of the SIMATIC MV540 H
CRANES camera is extended by 25% in the direction of trolley movement. Proper positioning of
the camera ensures that the reflector stays in the field of view of the camera even at greater
deflection angles.
Note
Apply a tightening torque of approximately 20 Nm
Apply a tightening torque of approximately 20 Nm:
• For the bolts used to attach the bracket to the trolley
• For the four setscrews at the ends of the bracket
• Use the two supplied M8 bolts to attach the housing and bracket to the trolley. Use the two
setscrews at each end of the bracket for precise perpendicular alignment. You can find more
information in the chapter Dimension drawings (Page 141)
SIMOCRANE CenSOR
Operating Instructions, 07/2021
WARNING
Installation/connection
6.3 SIMOCRANE CenSOR for an outdoor crane
43
Advertisement
Table of Contents
