ESAM AUTO (E A)
The ESAM Auto command instructs MCR to operate in the Emergency Stand-Alone Mode if
all carriers go into a level 2 alarm. Its display is similar to
screen
on page 85.
Figure 28: ESAM Auto (E A) screen
Note:
This configuration setting can be overridden by the faceplate ESAM toggle switch.
ESAM FORCE (E F)
The ESAM Force command instructs MCR to operate at all times in the Emergency Stand-
Alone Mode. Its display is similar to
Figure 29: ESAM Force (E F) screen
ESAM NEVER (E N)
The ESAM Never command instructs MCR not to operate in the Emergency Stand-Alone
Mode. Its display is similar to
Figure 30: ESAM Never (E N) screen
Note:
This configuration setting can be overridden by the faceplate ESAM toggle switch.
FIRMWARE
The FIRMWARE commands are reserved for future use.
Mini-Carrier Remote Fundamentals
Figure 29: ESAM Force (E F) screen
Figure 30: ESAM Never (E N) screen
Host MMI interface
Figure 28: ESAM Auto (E A)
on page 85.
on page 85.
March 2013
85