Avaya Communication Server 1000M Single Group Manual page 68

Installation and configuration
Table 17: T1 Line Build-out Table
534 – 655 feet
400 – 533 feet
267 – 399 feet
134 – 266 feet
0 – 133 feet
Defaults are SW3, position 1 ON and all others OFF, which corresponds to a T1 Line Build-
Out of shortest length and ESF framing mode. The MMI and SDI connections run at 9600 baud
and default to N,8,1.
Note:
Both T1s are set to the same cable distance and framing mode.
Connecting T1 carrier links to the MCR
In an MCR system, the T1 carrier links are routed to the cabinet and connected to the RMI
through the RMI Multi-I/O Cable Assembly (NT5D87) from the operating company demarcation
point.
Note:
Before connecting the T1 carrier link to the system, the connection between the operating
company demarcation point, such as a CSU, is completed using the NT7R87BA T1 CSU
Cable Kit.
Using the MMI command SET SPAN (S S), program the number of T1 channels supplied
by your service provider. Refer to
this process.
Main distribution frame connections
Connect subscriber loop (tip and ring) cables to the cabinet. Use 50-pin connectors J1 through
J10. These cables have already been connected to the Main Distribution Frame (MDF) in the
preinstallation preparation phase according to the instructions in Avaya Communication Server
1000M and Meridian 1 Large System Installation and Commissioning, NN43021-310 and
Avaya Communication Server 1000M and Meridian 1 Small System Installation and
Commissioning, NN43011-310:
1. Remove the locking bar from connectors designated J1 through J10.
2. Install the 50-pin connector terminating the MDF cable marked J1 and plug it into
68 Mini-Carrier Remote Fundamentals
LENGTH
the connector at the bottom of the cabinet also designated J1.
Comments? infodev@avaya.com
RMI SW3 Position (1 = ON, 0 = OFF)
1
0 0
0 0
0 1
0 1
1 0
SET SPAN (S S) on page 96 for a detailed description of
2 3
0
1
0
1
0
March 2013