Avaya Communication Server 1000M Single Group Manual page 89

SET ALARM (S A)
This command configures two properties of MCR's alarm system:
1. the number of errors the system will allow before signaling an alarm — threshold
2. the length of time that MCR will signal the alarm — duration
The command's display is similar to
Figure 35: SET ALARM (S A) screen
SET CONFIG (S C)
This command equips or unequips the T1 carriers. Its display is similar to
CONFIG (S C) screen
Figure 36: SET CONFIG (S C) screen
SET DATE (S D)
This command configures the date kept at the near end of the system. Its display is similar to
Figure 37: SET DATE (S D) screen
Figure 37: SET DATE (S D) screen
Mini-Carrier Remote Fundamentals
Figure 35: SET ALARM (S A) screen
on page 89.
on page 89.
Host MMI interface
on page 89.
Figure 36: SET
March 2013 89